media
punch_config
pcfg
Trendsetter_400/800_Auto
The AutoPunch is an automatic punching unit built by Ternes Register System that
sits between the Trendsetter AL unload table and the processor line.
The punch_config parameter specifies the punch configuration value associated
with the media type. Making the punch configuration a media parameter allows the
operator to change the punch configuration from the workstation.
Ternes will have configured the punch for different plate sizes, and will have defined
a number between 1 and 19 for each configuration. This configuration number should
be put into the punch_config parameter.
A different media type must be setup for each different punch configuration. The command
"punch media <src> <dest>" has been added to facilitate the task of copying media and hdm
parameters from one media type to another.
This parameter should be set to 0 for media types that are not to be punched.
byte
0 (disabled)
0 to 19
This parameter is only available on MPE V1.30 and above.
Punching requires both the punch and the rotator to be installed ("al ri" and
"al pi" set to 1).
cal